- Home
- Kits
- Kits - upgrade Tube Amp
- CCS Zero temperature coefficient current source
CCS Zero temperature coefficient current source for tube phase Inverter
CCS Zero temperature coefficient current source for tube phase Inverter
| Manufacturer: | TES |
| Price : | 23,00 € |
All VTA designs using the LM334 for the Phase Inverter tail suffer thusly: long warm up time, temperature sensitivity and balance instability. This can be remedied very easily.
Due to the LM334 instability, the Phase Inverter gain constantly changes, and as a consequence, the image wanders. The amps never reach equilibrium.
At a minimum, move the compensated LM334 to the underside of the driver board. Note the orientation of the compensated LM334. On the bottom, the LM334 rounded side is toward the transformers. Mounting under the board will prevent some heating by the tubes, helping to stabilize thecompensated LM334. The current may not achieve design values quickly as the internal chassis temperature rises slowly.
For the Temperature Compensated Full Monty:
CCS parts go on the PCB underside as shown. The amp now very stable. With compensation, the LM334 stabilizes rapidly and does not drift. Sonic image now remains rock solid. Phase splitter balance is surprisingly good, tracking perfectly from naught to clipping.
Goods of the same category - CCS Zero temperature coefficient current source for tube phase Inverter
ST-70 & AB, ultimate ST-70 VTA upgrade kit, auto bias INSTALLATION AND USER MANUAL FOR THE AB-Q-ST70-ST120 AUTO BIAS MODULE Introduction: This module has been designed to maintain a constant bias voltage through all power output tubes for your ...
ST-70, PC-3 driver - ECF82, 6GH8, 6F2 DYNACO ST-70 - DRIVER 6GH8 ECF82, 6F2 Introduction: PC-3 driver board completely assembled, including tubes 6F2 (ECF82)
ST-70 & AB, ultimate ST-70 upgrade kit, auto bias PC-3 driver - ECF82, 6GH8, 6F2 DYNACO ST-70 - DRIVER 6GH8 ECF82, 6F2 Introduction: This module has been designed to maintain a constant bias voltage through all power output tubes for your ...
Dynaco MKiii & AB, ultimate MKIII upgrade kit, auto bias for 6SN7 tubes Amplifier installation diagram Resistor R39 in the bias source must be replaced with a value of 15 Ohm
Dynaco MKiii & AB, ultimate MKIII upgrade kit, auto bias for tubes 12AU7 Amplifier installation diagram Resistor R39 in the bias source must be replaced with a value of 15 Ohm
Assembled driver autobias I offer the latest autobias power driver kit. Reliable power signal for triode and pentode PP drive with four power tubes.Indication of autobias, delay of anode current growth after switching on the amplifier. Automatic ...