- Home
- Kits
- Kits - upgrade Tube Amp
- Power driver with autobias for PushPull of triodes or pentodes
Power driver with autobias for PushPull of power triodes or pentodes
Assembled driver autobias
| Manufacturer: | TES |
| Price : | 98,00 € |
I offer the latest autobias power driver kit. Reliable power signal for triode and pentode PP drive with four power tubes.Indication of autobias, delay of anode current growth after switching on the amplifier. Automatic control of continuous perfect symmetry of PP degree currents.A revolutionary look and great sound!The driver and autobias is assembled. You will need to solder the connection wires to the amplifier according to the detailed diagrams that are included.
Use:
Set includes:- Russian oil capacitors and other brand capacitors- quality metal film resistors- ceramic Gold Plated noval Tube Sockets- the necessary hardware to install the printed circuit to the amp chassis- Fully assembled auto bias module Note:The cathode current tubes are set only once for each as instructed in the wiring diagram..Trimmer on driver sets exact symmetry of inverse signals at points A and B.No additional settings. The parameters are shown in the diagram. Tubes are not included.
|
|
Goods of the same category - Power driver with autobias for PushPull of power triodes or pentodes
CCS Zero temperature coefficient current source for tube phase Inverter completely removes the distortion caused by the heated amplifier. Suitable for drivers DYNA-70, ST-70 VTA and other CCS inverters All VTA designs using the LM334 for the Phase ...
ST-70 & AB, ultimate ST-70 upgrade kit, auto bias PC-3 driver - ECF82, 6GH8, 6F2 DYNACO ST-70 - DRIVER 6GH8 ECF82, 6F2 Introduction: This module has been designed to maintain a constant bias voltage through all power output tubes for your ...
Dynaco MK III & AB, ultimate MK III upgrade kit, auto bias for 6SN7 tubes Amplifier installation diagram Resistor R39 in the bias source must be replaced with a value of 15 Ohm
Dynaco MK III & AB, ultimate MK III upgrade kit, auto bias for tubes 12AU7 Amplifier installation diagram Resistor R39 in the bias source must be replaced with a value of 15 Ohm
ST-70, PC-3 driver - ECF82, 6GH8, 6F2 DYNACO ST-70 - DRIVER 6GH8 ECF82, 6F2 Introduction: PC-3 driver board completely assembled, including tubes 6F2 (ECF82)
Dynaco MK IV & AB, ultimate MK IVi upgrade kit, auto bias for tubes ECF82, 6U8, 6GH8, 6GH8, 6F2, ECF80 DYNACO MK4 Auto Bias All described in the manual pdf in the "Download" section Preparation • Disconnect relevant wires from the original PCB ...
ST-70 & AB, ultimate ST-70 VTA upgrade kit, auto bias INSTALLATION AND USER MANUAL FOR THE AB-Q-ST70-ST120 AUTO BIAS MODULE Introduction: This module has been designed to maintain a constant bias voltage through all power output tubes for your ...
